Difference between revisions of "Refurbishing Skate Wheels"
From Pvdwiki
| Line 11: | Line 11: | ||
DO NOT inhale the smoke or grinding dust from urethane or any elastomer or plastic. It is toxic. | DO NOT inhale the smoke or grinding dust from urethane or any elastomer or plastic. It is toxic. | ||
| + | ===External Links=== | ||
| + | [http://www.gallaghercorp.com/guide/machining.shtml gallagher corporation]] | ||
[[category:skateboard]] | [[category:skateboard]] | ||
[[category:wheels (Skateboard)]] | [[category:wheels (Skateboard)]] | ||
Revision as of 19:58, 30 October 2006
To turn a new surface on a set of used (or new) skate wheels, you will need access to a lathe and a special mandrel to hold each wheel.
This mandrel was made using some 22mm shaft (same size as 608 bearing OD) that I had laying around. I also ordered a 22mm collet to hold the mandrel for maximum precision.
A specially shaped bit must be used to cut urathane properly. It will have a very positive rake and deep chip breaker on the top, almost a knife edge.A turning surface speed of around 375 Ft./Min has been suggested.
Freezing the wheels may make it easier to produce a nice finish in some cases.
DO NOT inhale the smoke or grinding dust from urethane or any elastomer or plastic. It is toxic.
