Difference between revisions of "PVD Rigid 29er Fork"
(→The Specs) |
|||
| (4 intermediate revisions by the same user not shown) | |||
| Line 13: | Line 13: | ||
1.125" steerer.<Br> | 1.125" steerer.<Br> | ||
| − | === | + | ===Riding Impressions=== |
| + | |||
| + | The fork is way to stiff, even as a rigid fork. I will have to make a new fork that is more compliant. | ||
| + | |||
| + | It does look better on the bike, than off the bike. | ||
| + | |||
| + | ===The build=== | ||
[[Image:IMG 9301.jpg]]<br><br> | [[Image:IMG 9301.jpg]]<br><br> | ||
| Line 19: | Line 25: | ||
[[Image:IMG 9307.jpg]]<br><br> | [[Image:IMG 9307.jpg]]<br><br> | ||
| + | Fork end details.<br> | ||
| + | [[Image:IMG 9313.jpg]]<br><br> | ||
| + | |||
| + | Fitting the disk tab. Still some trimming to do.<br> | ||
| + | [[Image:IMG 9460.jpg]]<br><br> | ||
| + | |||
| + | Welded up. Note the breather hole welded over.<br> | ||
| + | [[Image:IMG 9464.jpg]]<br><br> | ||
| + | |||
| + | Turning the crown race to perfection.<br> | ||
| + | [[Image:IMG 9454.jpg]]<br><br> | ||
| + | [[Image:IMG 9456.jpg]]<br><br> | ||
[[category:Bicycle]] | [[category:Bicycle]] | ||
[[category:Frame Building]] | [[category:Frame Building]] | ||
Latest revision as of 15:55, 14 May 2007
This is part of my first solo effort at framebuilding. I have been part of teams building frames, but this time it's all me.
The bike is a silly rigid niner. I got a nice deal on tubes, and wanted to try some geometry tricks. I do not take this bike seriously. It is a first try and will probably end up as my wifes work bike.
The Specs
16.75" Axle to Crown, axially to steerer.
50mm offset.
100mm spacing.
15" axle to bottom of steerer, axially to steerer.
7 degree blade angle, on center.
Nova niner fork blades.
1.125" steerer.
Riding Impressions
The fork is way to stiff, even as a rigid fork. I will have to make a new fork that is more compliant.
It does look better on the bike, than off the bike.
The build
Fork end details.
Fitting the disk tab. Still some trimming to do.
Welded up. Note the breather hole welded over.
Turning the crown race to perfection.
