Difference between revisions of "PVD Tube Bender"
From Pvdwiki
(→The Failed Press Bender) |
(→The Compression Bender) |
||
| Line 20: | Line 20: | ||
Here is the solid model of what is currently being built:<br> | Here is the solid model of what is currently being built:<br> | ||
| − | [[Image:PVD-Tube-Bender.gif]] | + | [[Image:PVD-Tube-Bender.gif]]<br> |
| + | |||
| + | This model is not fully detailed yet. The radius is yet to be determined. | ||
[[category:Bicycle]] | [[category:Bicycle]] | ||
[[category:Frame Building]] | [[category:Frame Building]] | ||
Revision as of 20:59, 18 June 2007
Bending Concepts
This is from the Tools for Bending Bending Manual, p.3.
The Failed Press Bender
I first decided to make a press bender. It didn't work out too well. Either the radius of the bend was too tight, or the concept was not applicable to my standards, or a little of both.
I figured that this type of bender would make it easier to make mandrels for odd shaped tubes.
The Wheels. Skate bearings make it cheap.
On the press.
Crappy bend
Tool parts packaged up for storage.
The Compression Bender
Here is the solid model of what is currently being built:
This model is not fully detailed yet. The radius is yet to be determined.
