Difference between revisions of "2x9 ala PVD"
(→The Cassette) |
(→The Front Derailure) |
||
| Line 25: | Line 25: | ||
[[Image:2x9-4.jpg]]<br><br> | [[Image:2x9-4.jpg]]<br><br> | ||
[[Image:2x9-3.jpg]]<br><br> | [[Image:2x9-3.jpg]]<br><br> | ||
| + | ===Cable Routing=== | ||
| + | The front derailure needed down tube routing to work. | ||
===Chainline=== | ===Chainline=== | ||
Revision as of 21:01, 23 February 2007
The concept for this project was driven by my upcoming races at the 2007 Sea Otter Classic. I plan on competeing in Super D, Hardtail Downhill, and Cross Country on the same bike.
I have been riding my Six-Speed on trail with great results, but I will need more range for the Sea Otter races.
Contents
Narrow Range Front Gearing
Finding a crank that will run adequate gearing for a 2x trail bike is a bit difficult. One crank that is almost perfect from the box in terms of gearing is the Shimano FC-6603 Ultegra 10 Speed road triple crank. The smaller gears of the crank are 39 and 30. A very good spread.
This crank has a PVD Custom Bash Ring installed. I usually do not use bash rings, but a section of trail we have been riding lately requires draging ring over a few rocks to clean.
Chainrings
The 5 bolt chainrings are 130/74mm patterned. The 30 tooth is probably a little high. I'm going to change that out to 28t with a 11-32 cassette.
The Cassette
A standard 11-32 cassette would be nice for this bike. Better would be to tighten it up and move the first cog to 13 or 14 for improved performance.
I ended up with a 13-30 cassette at first, but just ordered the 11-32. Needed the lower and higher gears. The cassette was just to close.
The Front Derailure
A standard MTB front derailure will not work with the large road rings unless the derailure is raised fairly high on the seat tube. The cage will otherwise get caught up on the 30t gear.
I elected to try a Shimano FD-R770 front derailure for double. It allows the derailure to be placed low and close to the rings. Both styles of deraulure come very close to the rear tire.
Cable Routing
The front derailure needed down tube routing to work.
Chainline
The Ultegra 10 speed Triple cranks configured as a twin gear as I have done produces a chainline of 43.5mm. This is pretty bad. It brings the front derailure very close to the rear tire. Adding an additional 2.5mm spacer brings the line out to 46mm. Any more than this is very difficult to acheive.
The Shimano Road and Mountain bottom brackets and their shell and overall installed dimentions.
The Final Product
This is with a custom stacked 13-30 cassette.
